WARNING Data error (cyclic redundancy check) occurred inside byte range

During the backup of a Disk Image Protected Item, you may recevie a warning similar to:

WARNING: read \Device\HarddiskVolumeShadowCopy: Data error (cyclic redundancy check). occurred inside byte range xxxxxx - xxxxxx. Skipping this range, some files may be unrecoverable.

This error indicates a hardware failure with the hard drive or a component between it and the operating system. The Disk Image backup should be saved, but but with these byte ranges empty.

If you have recently replaced your hard drive, cloning the the old hard drive to the replacement, it is possible that some of the cloned data was corrupt on the old hard drive and has been replicated to the replacement. This issue can occue with 3rd party disk cloing tools where corrupt files from bad sectors on the disk will be replicated to the replacement hardware.

If you are confident that the hard drive and hardware (disk controller, SATA cables, etc) in the system is in good condigtion, you can try performing an on-boot chkdsk

chkdsk /B /X

• Right-click the “Start menu” and select “Windows PowerShell (Admin).” In the User Account Control (UAC) window, select “Yes” to give it permission to launch the Windows Command Processor and make changes. Type “chkdsk c: /x /r” without the quotes to scan it for errors, and repair it.
  
• Try replacing the SATA cables, and plugging the drive into another SATA port

• Confirm that the VMDK image is available for restore.
• Perform a test restore of the VMDK image, run your VMDK Disk Image in an application like Virtual Box to confirm you have a good backup.